Upgrade your CNC milling machine with a 4th rotation axis. The set includes the rotary table, the 4th axis module and the tailstock. Start today with ring engraving, thread millling and machining turning parts! The 4th axis module is simply plugged into the main control unit and screwed onto the retaining plate. The rotary table with three-jaw chuck and the the tailstock are secured on your T-slot table. Your CNC workpiece is clamped between the rotary table and the tailstock.
Note: For the application of the set you are in need of the full version of WinPC-NC USB, UCCNC or a comparable control software.
- Height of spindle: 32 mm
- Overall height: 55 cm
- Width: 42 mm (without shaft)
- Adjustable anti-Backlash worm gear, gear reduction: 54:1
- Half-step-mode: 21.600 Steps / Turn.....60 Steps/°....1 Step=1min.....1Step = 1' = 60"
- Collets: ER16 (1-12 mm)
- Concentricity: 0,1 - 0,2 mm
- Stepper Motor: Nanotec 1,8 A 1,8°
- Housing: Aluminium 7075
- All rotating parts are made of stainless steel
- Horizontal or vertical assembly
- Secured with screws M6
- Clamping range lathe chuck with reversible jaws inside 1,5 - 32 mm / outside 12 - 65 mm
- Clamping range outside Diameter horizontal: 50 mm
- Peak height: 32 mm
- Total height: 45 mm
- Screw path: ca. 10 mm
- Lockable with lock washer
- Material: aluminum 7075 anodized
- Ball-bearing live center
- Including retaining screw and T-nuts
- 4th axis module
- Rotary Table (with retaining screws for horizontal Installation, 9-pin Sub-D connector, cable length 50 cm)
- Tailstock (with center Point, 2x M6x15 retaining screws, 2x slot nuts M6)
